The crib is where your baby will spend
a lot of their time and you want to be
sure they are safe. Below are some of
the questions (with the answers) that
are asked about crib safety. Topics such
as mattress position, how to place your
baby in the crib, and general safety standards
are discussed, as are other issues. If
you need further information you can search
the Internet and visit baby furniture
stores.
Q. Are there safety standards for baby
cribs?
Yes there are some very exact standards
for your baby's crib. In 1974 it was made
law that cribs should no longer be painted
with lead based paint. It was discovered
that the ingestion of lead (from any source)
could cause learning disabilities and
other difficulties in young children.
The slats of the crib must be no more
than 2 3/8 inches apart, this is to prevent
your baby from getting his body or head
stuck between the bars causing injury
or strangulation. The side bar should
be 26 inches above the mattress when it
is in its lowest position. If your child
is more than an inch taller than the sidebar
it is time to move him into a regular
bed.
Q. Are there some hazards in my baby's
crib that I need to be aware of?
Your mattress must fit snugly in the
crib; an ill-fitting mattress could cause
your baby to slip between the mattress
and the side bar causing suffocation.
The mattress height should be able to
be adjusted into at least three different
levels. When your baby becomes more mobile
you will want to put the mattress in the
lowest position to prevent your baby from
climbing or falling out. The slats should
be tight, loose slats could pinch little
fingers. Do not put the crib near a window
to prevent your baby from possibly falling
out or becoming tangled in Venetian blind
cords.
Q. What are some historical facts about
the crib?
Here is a short chronological time line
of crib facts:
1973 - The standard for crib slats was
to be no more than 2 3/8th inches apart
to prevent your baby from slipping through
or getting their head stuck. Also, double
latches for drop-down sidebars were to
become the norm.
1976 - The standard for cutouts in the
crib end panels are presented. The end
panels must not have any decorative cutout
designs. Children were getting their limbs
or heads caught causing serious injury
or death.
1978 - Cribs must now be painted with
non-toxic finish.
1981 - Two models of cribs with cutouts
are recalled.
1988 - A voluntary standard addresses
mattress support hardware, failure of
glued or bolted connections, drop-side
latch failure and loosened teething rails.
1990 - No corner posts or projections
can be more than 1/16th of an inch above
the drop-side.
1998 - California and Washington mandate
that hotel cribs must meet the same standards
set for full-size cribs
1998 - Portable cribs must now meet the
same standards as full-sized cribs.
Q. How can I tell when my baby is ready
for a regular bed?
When your child stands more than a couple
of inches taller than the sidebar with
the mattress in the lowest position. If
your child is climbing out of the crib,
for his safety put him in a regular bed.
Q. How should I put my baby to sleep
in his crib?
Place your baby on his back or on his
side for sleeping. Use one piece sleepers
rather than blankets. Your baby could
slip under the blanket and possibly suffocate.
Remove all pillows and toys as well, in
order to prevent suffocation.
Q. Is it safe to cover my baby with a
blanket?
A blanket sleeper will keep your baby
sufficiently warm while sleeping. If you
absolutely need to use a blanket, tuck
it in around the bottom of the mattress.
Place your baby with his feet toward the
end-panel and the blanket should go no
higher than his/her chest.
Q. Is a mesh sided crib safe to use for
my baby?
Yes, a mesh crib is safe provided the
mesh is less than 1/4 inch in size, smaller
than a tiny button on baby's clothes.
The should be rips, tears, or loose threads.
If staples are used to attach the mesh
they must not be exposed and the mesh
must be securely attached to the top rail
and the floor plate.
Q. Can I safely use bumper pads in my
baby's crib?
While bumper pads are not necessary,
they can safely be used. They must be
very close the edge of the mattress and
properly secured. The bumpers must be
flat and not puffy, as your baby could
get stuck between the bumper and the mattress
and suffocate.
Q. What can I do to keep my baby's crib
safe?
In order to keep your baby's a safe place,
you should make sure to all connections
are secure and that there are no broken
or missing parts. Regularly, check the
teething rail for splits or cracks. Make
sure the mattress spring support and your
crib will withstand your baby's increasing
mobility. The mattress itself should have
no splits, tears, or holes.
Q. How can I tell when it's time to lower
the mattress?
When your baby becomes more active, when
s/he begins to pull himself to a standing
position or when he sits up alone it will
be time to lower the mattress to prevent
your little one from either climbing out
or falling out.
Q. Can I hang a mobile over my baby's
crib?
Mobiles and crib gyms can be used to
entertain your baby but when your child
is able to get on to their hands and knees
or pull themselves up. This will prevent
your baby from becoming entangled in them.
In Conclusion
Making sure your baby's crib is safe,
is an ongoing to task. Proper positioning
of the mattress, making sure all connections
are secure and that there are no loose
slats that could pinch little fingers
will help to keep your baby's crib a safe
place for him to be. Be sure to place
him in the crib on his back or side and
dress him in a sleeper rather than using
a blanket. Keeping these tips in mind
will help keep your baby safe and give
you some peace of mind.
About The Author
Martin Smith is a successful freelance
writer providing advice for consumers
on purchasing a variety of Nursery Bedding
which includes Baby strollers, Baby car
seats, and more! His numerous articles
provide a wonderfully researched resource
of interesting and relevant information.
For more information vist http://www.1st-babies.com